OZONE System for AirTub - How to install
1
INTRODUCTION
Ozone (O₃) is a highly effective natural disinfectant used to purify the water in ice baths. It eliminates bacteria, viruses, fungi, and other microorganisms, ensuring clean and hygienic water without the need for chemicals like chlorine. Additionally, ozone helps break down organic residues, reducing unpleasant odors and water cloudiness. With its powerful oxidizing properties, it enhances water quality, providing a safer and more refreshing recovery experience.
2
SAFETY & INFORMATION
-
Electrical Safety
Warning: Do not connect or operate the Ozone system in a power outlet if the electrical panel of your home or the location where you are using the device is not equipped with a Residual Current Device (RCD) or Ground Fault Circuit Interrupter (GFCI) and proper grounding. According to the law, all homes and facilities must be equipped with an RCD/GFCI anti-electrocution system in their electrical panels. If your electrical panel does not include such a system, do not plug in the UV lamp until you contact a licensed electrician to install the appropriate safety device. -
Warning ⚠️
-
Keep the module away from flammable materials.
-
3
MEDICAL DESCLAIMER
Our ice baths are designed for wellness and recovery but are not a substitute for medical treatment. We hold no responsibility for any medical issues arising from their use. Users of all ages, including children, pregnant individuals, the elderly, and even athletes, should consult a physician before using this product to ensure cold therapy is safe for them. Please note that by using this product, users assume full responsibility for any associated health risks.
4
COMPONENTS
5
INSTALLATION & SETUP
-
If you purchased the AirTub along with the OZONE system, you should first follow the AirTub Setup Instructions and then proceed with the OZONE system instructions to connect it to your AirTub.
-
If you already own an AirTub and have just received the OZONE system, please follow the steps below.
STEP 1:
To connect the OZONE to the AirTub, follow these steps:
-
Close the two red valves on the AirTub.
-
Disconnect the hose from the top valve of the AirTub and connect it to the B side of the OZONE unit.
-
Connect the A side of the OZONE unit to the top red valve of the AirTub.
STEP 2:
-
To operate the AirTub with the OZONE system, you will need a power strip with at least two sockets. One socket is for the AirTub, and the other is for the OZONE system. It’s recommended to connect both devices to a single power strip rather than separate outlets, allowing you to control them simultaneously.
*The power strip shown in the image is not included in our package, you will need to use one of your own.
💡Smart Control APP
-
If you have also purchased the Smart Control system we provide for the airtubs, you must plug the Smart Control into the power outlet and then connect the airtub to the Smart Control.
-
If you are also using a UV or ozone system, meaning you're using a power strip, you should connect the power strip to the Smart Control.
-
Important: Do not connect only the airtub or only the UV or ozone system to the Smart Control. The entire system must be connected through the Smart Control.
STEP 3:
-
You are now ready to operate the system. Open the two valves of the TUB again and turn on the chiller.
Placing the Ozone Device
-
The ozone device must be installed at a height higher than the water level. In other words, secure it somewhere, preferably on the wall, at a height equal to or above the level of the AirTub lid.
6
WARRANTY & SUPPORT
The OZONE Disinfection Module is covered under a 1 year warranty for manufacturing defects.
❌ Exclusions:
-
Misuse or unauthorized modifications
-
Improper maintenance
-
Physical damage due to external factors
If you encounter any issues that cannot be resolved using this guide, please contact our support team